RAVENOL Break-In Oil SAE 30 4L

RAVENOL Break-In Oil SAE 30 is a mineral running-in oil for the first filling and the running-in of repaired or revised engines.

It does not use additives to improve the friction value (friction modifier) ​​in order to significantly shorten the running-in phase for repaired and modified engines. The piston rings are set quickly.

Due to a high proportion of 2.5% ZDDP (zinc dithiophosphate) (this corresponds to approx.2,500 ppm zinc), RAVENOL Break-In Oil SAE 30 is particularly recommended for running in classic V8 engines with flat tappets.

Application note:
RAVENOL Break-In Oil SAE 30 serves as a classic running-in oil and may therefore only remain in the engine for a short time (max. 1000 km). The particularly high proportion of wear-inhibiting additives offers extra protection in the critical running-in phase of repaired engines. Please observe the specifications of your engine repair company during the running-in phase. Avoid high engine loads and speeds.

Attention: RAVENOL Break-In Oil SAE 30 is not suitable for vehicles with catalytic converters.

Properties Unit Data Density test at 20 ° C kg / m³ 881 EN ISO 12185 Color red visual Viscosity at 100 ° C Viscosity at 40 ° C mm² / s 11.0 906 DIN 51 562 Viscosity index VI 106 DIN ISO 2909 Pourpoint ° C - 27 DIN ISO 3016 Flash point (COC) ° C 248 DIN ISO 2592 Sulfate ash% wt. 0.9 DIN 51575
To the best of our knowledge, all information corresponds to the current state of knowledge and our development. We reserve the right to make changes. All references to DIN standards only serve to describe the goods and do not constitute a guarantee. In the event of problems, request technical advice.
As of October 22, 2019